This chip is similar to the , but it also includes XRAM support and supports the higher dot clocks of the This effectively means that there are two limits on the dotclock. The lower half of the screen is not accessible. That is from 0 to for 8bit depth, 0 to 32, for 15bit depth, etc. Optional AIC Ultra

Uploader: Yozshurisar
Date Added: 20 August 2011
File Size: 29.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33445
Price: Free* [*Free Regsitration Required]

This might make certain modes impossible to obtain with a reasonable refresh rate. Typically, the device driver for USB devices is managed by the.

Most of the Chips and Technologies chipsets are supported by this driver to some degree. This serial link allows an LCD screens to be located up to m from the video processor.

Installation of Ethernet driver The driver is capable of driving both a CRT and a flat panel display. If this is a problem, a work around is to remove the ” HWcursor ” option. There is the limit of the maximum dotclock the video processor can handle, and there is another limitation of the available memory bandwidth. You cannot cihps because 690000 article is private.

Options related to drivers can be present in the Screen, Device and Monitor sections and the Display subsections. A ” letterbox ” effect with no stretching can be achieved using this option.


Please read chipe section below about dual-head display. The Chips and Technologies driver release in X11R7. For this reason a mode that is as close to VESA like as possible should be selected.

You are probably using a dot clock that is too high or too low ; it is also possible that there is interference with a close MCLK.

Скачать драйверы для Chips and Tech. PCI (TOSHIBA)

For a complete discussion on the dot clock limitations, see the next section. This also gives more memory bandwidth for use in the drawing operations.

Operating system information and software drivers Org releases later than 6. However the panel size will still be probed.

In fact if the video BIOS on the machine sets the ct to a dual channel mode by default, X will lockup hard at this point. Although the authors of this software have tried to prevent this, they disclaim all responsibility for any damage caused by the software.

Subscribed unsubscribe Subscribe Subscribe. The overlay consumes memory bandwidth, so that the maximum dotclock will be similar to a 24bpp mode. Optional AIC Ultra However, some machines appear to have this feature incorrectly setup.


Chips and Technologies Video Drivers Download

Please try again later. Additionally, the ” Screen ” option must appear in the device section. You are using a mode that your screen cannot handle. Hence you will see a line like. That is from 0 to for 8bit depth, 0 to 32, for 15bit depth, etc.

Therefore to use this option the server must be started in either 15 or 16bpp tdch. For this reason it is recommended to use one of the programs that automatically generate xorg.

ShieldSquare reCAPTCHA Page

However, 8 and 24 bit colour depths seem to work fine. This will prevent the use of a mode that is a different size than the panel. Some machines that are known to need these options include.