Select your boot device priority by LS Give your computer the best, trust A-Tech! A-Tech is… read more. Pull the rod to the degree directly. There are two types: The hard disk will not work properly if you enter improper information for this category. Replace the screw to secure the slot bracket of the expansion card.

Uploader: Ditaur
Date Added: 2 February 2017
File Size: 46.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54615
Price: Free* [*Free Regsitration Required]

Use a grounded wrist strap before handling computer components.


The program that allows users to modify the basic system configuration. It allows you to limit access to the system and Setup, or just to Setup.

Then push it down. Just cut the bottom portion of the spacers the spacer may be a little hard to cut off, so be careful of your hands. Remove memory modules only when AC power cord is disconnected.

Serial interface standard set by Institute of Electrical and Electronics Engineers, which has features like high speed, high bandwidth and hot plug.


Install related driver from the operating system. A-Tech is… read more. Optimized Defaults Figure 5: Enabled Enable USB keyboard or mouse support. Set User password Change, set, or disable password.

Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Sounnd protect them against damage from static electricity, you should follow some precautions whenever you work on your computer. Dispose of used batteries according to the manufacturer’s instructions.

Sometimes you may need to use the plastic springs to isolate the screw from the motherboard PCB surface, because the circuit wire may be near by the hole. The red stripe of the ribbon cable must soun the same side with the Pin1.

Devices like printer can be connected to Parallel port; mouse and modem etc. The hard disk will not work properly if you enter improper information for this category.

Auto BIOS will automatically setup the port 1 address.

[Pi] MB GA-8SGXP – pc tries to boot – Fujitsu Support Forum

Turn on the power supply or connect the power cable to the power outlet. Locate Pin 1 in the socket and 3.


Remove your computer’s chassis cover, screws and slot bracket from the computer. In order to utilize the front audio header, your chassis must have front audio connector.

Disabled Disable onboard 1st channel IDE port. Integrated Peripherals This setup page includes all onboard peripherals. It might cause soune or other unexpected damages due to the stand by voltage.

Designed For Clevo Notebook: Be careful with the polarity of the IEEE connector. Replace only with the same or equivalent type recommended by the manufacturer. You will be asked to confirm the password. Optimized Defaults Figure 7: Designed For Dell Dimension: Disabled Enabled Don’t display Intel brand logo. It supports K, 1.