The first connector is a 4-pin header that brings out 3. The white headers are the signal lines, the red headers provide 5V and the black headers provide ground. It is strongly encouraged to use external power supply to power the motor shield. Navigation Main page Random page Recent changes Help. Views Read View source View history. Built-in Schottky diodes to protect against motor back EMF. This Arduino motor shield allows for motor control with Arduino right away.

Uploader: Mikak
Date Added: 13 August 2007
File Size: 40.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 5530
Price: Free* [*Free Regsitration Required]

The Motor shield can be powered directly from Arduino or from external power source. DC MotorServoShield. These motor drive leads also have yellow and green LEDs attached to them. To use the servo, you will need to have a minimum of 6. High-speed drive capability, can drive ordinary 2-phase stepper motor to RPM, and drive quad DC at the same time.

Ks Shield LP 2A High Current Dual DC Motor Driver Module – Keyestudio Wiki

The VMS is the positive motor voltage which can range from 4. D4 D5 D6 D7. There is also a 3-pin blue header that that brings out 5V, ground and D2 that can be used for a digital sensor or other remote connection. The motor power comes in on the 2-pos screw terminal. Retrieved from ” http: When the jumper is installed, the power from the motor VMS power connector is connected to the Vin pin on the Arduino which feeds the Arduino on-board 5V regulator.


There is another version of 2x2A motor shield Twin which uses different pins to avoid conflicting pin allocation. Basically if the motor goes in the opposite direction than you expect, simply reverse the wiring for that motor.

Pin 4,5,6,7 are used to drive two DC motor. D10 controls speed of motor A and D11 controls speed of motor B. Use mirror motor to drive DRI to aviod the conflicts.

Reviews There are no reviews yet. These motor connection points are also mirrored on a 4-pin female header for a little more flexibility. Motor drive using pins.

Usually there are 2 pins used to determine the direction of rotation for each motor, but this shield has an inverter that provides an inverted version of the signal to the two pins. The first connector is a 4-pin header that brings out 3. D3 is for controlling the speed of motor A, and D12 is for controlling the direction of motor A. This should be avoided.

The shield uses D9 for the PWM signal. D11 is for controlling the speed of motor B, and D13 is for controlling the direction.


Ks0007 Shield L298P 2A High Current Dual DC Motor Driver Module

It is also used to power the logic portion of the LP chip. This board brings out the A0-A5 pins to a row of headers that also provide separate power l98p ground points for each A0-A5 pin. The program below runs the DC motor control portion through a sequence of events. But most projects at some point require mobility. Their brightness will vary depending on the strength of the PWM signal.

L298P Motor Driver Shield

When this jumper is removed, the Arduino must be powered separately. Drive 1 servo motor with a dedicated 5V regulated power.

The other Bluetooth header is a pin male header. This arduino motor shield is ideal for building Arduino robot or other Arduino motor control projects.

This Arduino motor shield allows for motor control with Arduino right away. Servo motors are 3 wire devices. Your email address will not be published.